0 Items in Your Cart

Dennis Behn - Artistic Explorations Blog

Email Subscription Sign Up

request catalog

Clearance Items


Using Slow Set Bond-Tite

Designed for the commercial taxidermist that requires a quick setting epoxy with superior adhesion, high viscosity and easy clean-up. Van Dyke's Slow Set Bond-Tite Epoxy is the perfect solution for glue that will hold extremely well on all types of earliners.

Mixing Directions:

Mix desired amount 50 x 50 resin and hardener.

Spread thin layer to earliner and skin and apply pressure.

Fast Set Bond Tite will dry in 10 to 20 minutes, depending on ambiant temperature.

Slow Bond Tite will dry from 2 to 4 hours.

Adhesive may also be used as an all purpose adhesive to bond just about any stiff surface.

Surface Preparation:

All surfaces should be free from oil, grease, dirt, waxes, old paint, rust and chemical contamination.


Store unopened in a cool, dry place.

Tightly seal lid when not in use.


Keep Out of Reach of Children

Wash hands with soap and water after use or wear gloves.

Not for internal use. If swallowed do not induce vomiting- call physcian.

Eye contact was with water for 15 minutes and see physician immediately.

Note: Van Dyke's Taxidermy Supply Co. offers these instructions in an advisory capacity and assumes no liability. Such information is the same as used in our own successful experiments, and since we have no control over the environment or the materials upon which our products or instructions will be used, no success is guaranteed. Trial must be performed to account for individual circumstances. In all suggestions, we recommend reading the formulas that have been provided for your evaluation. These are proven formulas that you may find beneficial, from the experience of other tanners.

Go Back