Skull Attachment Instructions:

1. Center the skull on the front of the panel and mark the two points where the two 3" screws will enter the thickest part of the bottom of the skull.

1. Drill two 3/16" holes at the pre-marked points.

1. Attach the pedestal support to the front panel using the 1 1/2" wood screws.

1. Use the 3" wood screws to attach the skull to the front panel.

2. The bottom of the skull has a bone structure that is thin in nature. Do not over tighten the screws. You can repair a skull that the screws will not hold by filling the brain cavity with Bondo that has been thinned down slightly with polyester resin. Carefully pour this catalyzed resin into the brain cavity and allow to harden.

3. Attach the sawtooth hanger to the wall mount panel using the two nails.

4. Attach the wall mount to the pedestal support using the 1 1/2" wood screw.

5. The skull and panel are now ready to hang on the wall.

Go Back