|
Safety Instructions for Use of Skife Knife and Replacement Blades
Attention:
The fleshing guide on your skife knife should be the same radius as the blade radius. Also the fleshing guide should be only 1/16" to 1/8" lower than the blade.
If guide needs to be re-bent, simply place Skife Knife, blade side down, on table and while hanging onto the handle with one hand tap inside radius of blade guide down with a ballpean hammer or small hammer. Tap along radius of guide whenever necessary. Face fleshing is a delicate operation; therefore, the skife knife should be re-bent if necessary!
Remove dull skife knife blade and insert replacement blade with a flat tipped screwdriver. Failure to observe this simple method could result in cuts on your fingers and thumbs.
-
Bring blade in to metal fold from the backside.
-
After the end is slightly started into fold continue to slide forward to the working position by means of a flat-tipped screwdriver.
-
Always push blade away from your body and make sure there is nothing that can get hurt or damaged in front of the tool.
Go Back
|