Using CartilageLiner Ear Adhesive

McKenzie Cartilage Liner Ear Adhesive is designed for use with the CartilageLiners.

This glue will adhere to all earliner materials. Roughing the surface with a Stout Ruffer will enhance adhesion. For best results, place some adhesive inside the ear skin as well as to the earliner surface.

CartilageLiner Adhesive may also be used as a general-use hide paste. Use as you would any epoxy glue.

Mixing Instructions for Two Part Kit:

Mix one part resin to one part hardener by volume until mixture is even in color. Material will set firmly in about 2 hours.

Clean hair with water before material sets.

Wash hands with soap and water.

Storage: Store unopened containers in a cool, dry area. After containers have been opened it is recommended that they be tightly closed when not in use to ensure consistent performance.

Caution:

Do not swallow. If swallowed do not induce vomiting - call physician immediately.

If contact with eyes occurs, wash with water for 15 minutes and seek immediate medical attention.

If sensitive skin use surgical gloves. Wash with soap and water.

Wash hands after each mixing with soap and warm water.

Avoid clothing contamination.

Keep Out Of Reach Of Children

Note: Van Dyke's Taxidermy Supply Co. offers these instructions in an advisory capacity and assumes no liability. Such information is the same as used in our own successful experiments, and since we have no control over the environment or the materials upon which our products or instructions will be used, no success is guaranteed. Trial must be performed to account for individual circumstances. In all suggestions, we recommend reading the formulas that have been provided for your evaluation. These are proven formulas that you may find beneficial, from the experience of other tanners.

Go Back